Leveling Your Wine Cellar; Installation Limitations; Proper Air Circulation - Cuisinart Private Reserve CWC-800CENS Manual De Instrucciones

3. With both units in an upright position, lift
up the left-side unit (CWC-800CENL)
slightly, placing the two legs into the
connectors on the right-side unit (CWC-
800SCENR).
4. Align the left-side unit (CWC-800CENL)
and the right-side unit (CWC-800SCENR)
so they are as close together as possible.
To secure the units into position, turn both
front and rear legs of the left-side unit
(CWC-800CENL) counterclockwise until
tight.
5. Take connecting plug from back of the
left-side unit (CWC-800CENL) and plug
into back socket of the right-side unit.
6. Plug the power cord from the right-side
unit (CWC-800SCENR) into a standard
electrical outlet and the unit will turn on
automatically.
CONTROL PANEL FOR EACH UNIT
ALWAYS REMOVE ALL WINE BOTTLES
BEFORE MOVING THE WINE CELLAR.

LEVELING YOUR WINE CELLAR

Each wine cellar has 4 leveling legs. After
properly placing your wine cellar in its final
position, you can level it. (Please note that
the leg that stands on hinges is the shorter
leg.) Leveling legs can be adjusted by
turning them clockwise to raise the wine
cellar, or by turning them counterclockwise
to lower the cellar.

INSTALLATION LIMITATIONS

Do not place heavy objects on top of the
unit. Do not place the unit in a moist area
or in direct sunlight.
Do not place the unit next to a major
appliance that emits large amounts of heat,
such as a dishwasher, microwave, toaster
oven, oven or barbecue, etc.
Do not install your wine cellar in any location
not properly insulated or heated (garage,
etc). Select a suitable location for the wine
cellar on a hard, level and even surface,
away from direct sunlight or heat source,
e.g., radiators, baseboard heaters, cooking
appliances, etc. Any surface unevenness
should be corrected with the leveling legs
located on the front and rear bottom corners
of the wine cellar. Avoid placing unit where
there may be electrical interference.
NOTE: To minimize the risk of rusting,
leakage and insulation damage, avoid
placing the unit where heavy moisture is
present. Under no circumstances spill or
directly apply water onto or into the unit.

PROPER AIR CIRCULATION

To assure that your wine cellar works at the
maximum efficiency for which it was de-
signed, you should install it in a location
where there is proper air circulation and
electrical connections.
NOTE: The wine cellar is designed for
5