Automatic Station Search; Recalling A Preset Station; Scan Setting - Schwaiger DABWORK2 513 Manual De Instrucciones

USER GUIDE

Automatic station search

You can also search for an FM radio station automatically. To do this, press and hold the tuner control
knob (9) for about 1 second. The product now automatically searches the FM frequency band for the
next available station. The search ends automatically as soon as an available station is found. This is
then played back.
You can also determine whether the frequency band should be searched upwards or downwards for a
station.
To do this, perform a short manual station search. Depending on whether the frequency band is to be
searched upwards or downwards, first turn the tuner control knob (9) to the left or right. Then press
and hold the tuner control knob (9) again for about 1 second to start the automatic search in the
specified direction. The search ends as soon as an available station is found.
Please note that the reception of radio stations via FM can vary in different regions and not all stations
may be available. To improve radio reception, change the location of the product or the orientation of
the antenna (12).
Save station
You can also store up to 40 radio stations on the preset buttons for fast access in FM mode. To do this,
follow the steps described below:
• Select a radio station by searching for it manually or automatically as described above.
• To place the station, you have found directly in programme presets 1, 2 or 3, press and hold the pre-
set 1 button (11), preset 2 button (10) or preset 3 button (7) for about 1 second. The selected
programme memory location and the text „stored" appear briefly in the display. The radio station
has now been successfully stored on the selected preset button.
• If you want to store a found station on one of the programme memory locations 1 to 40, press and
hold the preset 4+ button (8) for approx. 1 second. The selection list of presets 1 to 40 appears.
Turn the tuner control knob (9) to the right or left to select the desired preset. Then confirm your
selection by pressing the tuner control knob (9). The selected programme memory location and the
text „stored" appear briefly in the display. The radio station has now been successfully stored in the
selected memory location.

Recalling a preset station

To recall a stored FM station, press the corresponding preset button on the product.
You can play the stations stored in presets 1, 2 and 3 directly by briefly pressing the preset 1 button
(11), preset 2 button (10) or preset 3 button (7) once. The station stored there is then played back.
To call up a station stored in presets 1 to 40, briefly press the Preset 4+ button (8) once. This takes
you to the complete station memory list. Now turn the tuner control knob (9) to the right or left to
select the desired station. Then confirm your selection by pressing the tuner control knob (9). The
selected station is then played back.
If you select a programme memory location that is not occupied, the text „Preset empty" appears
briefly in the display and the last radio station played is played.

Scan setting

The product has different search settings in FM mode. To select them, proceed as follows:
1. Press the menu button (4) to enter the submenu of FM radio reception.
2. Turn the tuner control knob (9) to the right or to the left until the item „Scan setting" appears in
the display. Select it by pressing the tuner control knob (9) once.
3. You can now select whether all available stations („All stations") or only stations with a strong
signal („Strong stations only") are to be played during a search. Select the desired setting by
turning the tuner control knob (9) to the left or right. Confirm your selection by pressing the tuner
control knob (9).
26