Use And Operation; Important - auna Karaoke Star 3 Manual De Instrucciones

EN
20

USE AND OPERATION

Select a sound source
1 Turn the VOLUME button to the lowest first. Switch the unit on. Use
input signal button to select the sound source.
2 Turn the VOLUME butt on to adjust Left and Right channel to a suitable
level.
3 Use the USD play buttons to adjust the MP3 music playback.
4 Use the TREBLE button to adjust the treble to a suitable level.
5 Use the BASS button to adjust the bass to a suitable level.
6 Use the BALANCE button to adjust the volume level of R/L CH.
Wiring the speakers
IMPORTANT: Turn off your amplifier before connecting or disconnecting
speakers
• Ensure that you connect the positive speaker terminal (red) to the
positive (red) amplifier speaker output. Take care to ensure that the
polarity is preserved ie do not connect the negative speaker terminal to
the positive amplifier speaker output.
• Repeat for the negative speaker terminal (black) and the negative
(black) amplifier speaker output.
Function Test
Once connected, turn on system start at a low volume and increase
gradually to a comfortable volume level. The system should sound balanced
with good sound reproduction. If the set sounds distorted check to make
sure that the speakers have been correctly wired with your amplifier.
Playing Karaoke
1 Turn the VOLUME button to the lowest first.
2 Switch the unit on.
3 Use the input signal button to select the sound source.
4 Turn the MIC1/2. VOL button to the lowest, plug 1 or 2 microphones into
the MIC1 or MIC2 Jack, adjust the MIC1. VOL & MIC2. VOL controls to a
suitable level.
5 You can adjust the microphone echo by using M. ECHO button.