Duramaxx Angkor Manual De Instrucciones página 22

EN
1 Down tube
2 Rubber seal
3 Screw
4 Nut
22
ASSEMBLY
1
Take the search coil and the down
tube out of the box. Loosen the
screw on the down tube and remove
the bolt. Slide the down tube onto
the search coil and fasten it. Make
sure that the seal is properly seated.
3
Press down the silver button (arrow)
on the top tube and slide it into the
middle tube.
2
Take the top tube and the control
unit out of the box. Loosen the two
triangular set screws on the bottom
of the control unit and remove the
control unit.
4
Align the silver knob (arrow) with
the two holes in the centre tube.
Push the two set screws through the
pipe from below and fix the control
unit.