Setup And Operation; Cleaning And Care - Klarstein ST.-OBERHOLZ 2G Manual De Instrucciones

EN
14

SETUP AND OPERATION

• For optimal air circulation, make sure that the ioniser is at least 30 cm away
from walls and other large objects.
• Place the unit on a table or shelf.
• Before connecting to the mains, make sure that the grille is inserted correctly.
• Press down the tab with your thumb to release the grille and remove it
upwards.
• To reinsert it, first insert the bottom into the ioniser. Then press the upper part
of the grille in and let it snap into place.
• Keep your fingers away from the sharp edges.
• First, plug the mains cable into the connector on the back of the unit. Then,
connect it to the power socket.
• You are now ready to use the ioniser.
• In whisper mode, the unit uses negative ions to attract dirty air, trapping the
dirt and releasing clean, healthy air.
Turbo mode
Use this mode to eliminate strong odours in a short time. It uses the same
technology as the whisper mode, supplemented by a fan that increases air
circulation and makes the air purifier even more effective.

CLEANING AND CARE

Note: After using the ioniser for a long time, the grille must be cleaned. Clean it
at least once a month or even more often depending on the place of use.
1. Disconnect the appliance from the power supply before cleaning.
2. Remove the grille.
3. Wipe the dust off with a damp cloth. Keep your fingers away from sharp
edges. Do not use detergents to dampen the cloth. Only use water.
4. Dry the grille with a cloth.
5. Reinstall the grille.