Schluter Systems DH E RT6/BW Guía Rápida página 4

English
Manual connection:
The "Searching networks" screen is displayed while
the thermostat is searching for available networks. The
detected networks are then displayed in a list.
7. Tap the name of the desired network on the list.
If you cannot see the name of your network on the
list, you have to enter the network name manually
in the following way:
• Tap "Other" at the bottom of the list of networks.
• You are now asked to enter the network name
(SSID). Tap the "Right Arrow" button to proceed.
• Enter the network name (SSID) for your wireless
network at the top of the screen.
• Confirm the network name with "√"
8. You are now asked to enter the network key
(password). Tap the "Right Arrow" button to
proceed.
9. Confirm the network key with "√" to start
connecting the thermostat.
The thermostat will now attempt to connect to your
wireless network. Please be patient, since this may take
a while (several minutes).
• If the connection is successful, a confirmation screen
will be displayed briefly.
After that the "Status" screen will be displayed
showing the current status of the WiFi connection.
Tap the "Left Arrow" button to return to the menu.
• If the connection fails, the thermostat will tell you so.
In this case, check troubleshooting, and then tap the
"X" button to return to step 4 and try again.
If problems persist, or if anything unexpected happens
during setup of the WiFi connection, please consult the
"Troubleshooting" section in the on-line User Manual.
4
© 2022. All rights reserved. Used under license by Schlüter-Systems KG
DH E RT6 / BW