Charging The Battery Pack; Specific Safety Rules - Terratek TPDC18134 Manual Del Usuario

Battery use and care
A battery operated tool with integral batteries or a separate battery pack must be recharged
only with the specified charger for the battery.
A charger that may be suitable for one type of battery may create a risk of fire when used
with another battery.
Use battery operated tool only with specifically designed battery pack.
Use of any other batteries may create a risk of fire.
NEVER place hands or other body parts near the drill bit or chuck during operation.
Hold the drill by its handle only. Because the cordless driver drill operates by battery power,
be aware of the fact that it can begin to operate at any time.

Charging the battery pack

Charge battery for 3-5 hours only, when you plug battery into the charger the "GREEN"
light will come on, there is no light to indicate the battery is fully charged, charge only
for 3 to 5 hours, unplug charger and remove battery from charger.
Battery charger LED function
Charger plugged in: Red light "ON"
Battery charging: Green light "ON"
WARNING: Improper use of the battery or battery charger can lead to serious injury.
To avoid these injuries:
A) NEVER disassemble the battery.
B) NEVER incinerate the battery, even if it is damaged or is completely worn out.
The battery can explode in a fire.
C) NEVER short-circuit the battery.
D) NEVER insert any objects into the battery charger's air vents. Electric shock or damage
to the battery charger may result.
E) NEVER charge outdoors. Keep the battery away from direct sunlight and use only
where there is low humidity and good ventilation.
F) NEVER charge when the temperature is below 32°F (0°C) or above 104°F (40°C).
G) NEVER connect two battery chargers together.
H) NEVER insert foreign objects into the hole for the battery or the battery charger.
I) NEVER use a booster transformer when charging.
J) NEVER use an engine generator or DC power to charge.
K) NEVER store the battery or battery charger in places where the temperature may
reach or exceed 104°F (40°C).
L) ALWAYS operate charger on standard household electrical power (120 volts).
Using the charger on any other voltage may overheat and damage the charger.
M)ALWAYS wait at least 15 minutes between charges to avoid overheating the charger.
N)ALWAYS disconnect the power cord from its receptacle when the charger is not in use.

Specific Safety Rules

1) Hold power tools by insulated gripping surfaces when performing an operation where the
cutting tool may contact hidden wiring.
All manuals and user guides at all-guides.com
9