Respecting And Conserving The Environment; Maintenance And Care; Troubleshooting - Hotpoint Ariston PKQ 644 D GH (K) /HA Manual De Instrucciones

on the product reminds you of your obligation, that when you dispose of
GB
the appliance it must be separately collected.
Consumers should contact their local authority or retailer for information
concerning the correct disposal of their old appliance.

Respecting and conserving the environment

water as possible. Cooking with the lid off will greatly increase energy
consumption.
• If you are cooking something that takes a long time, it's worth using a
pressure cooker, which is twice as fast and saves a third of the energy.

Maintenance and care

Switching the appliance off
Disconnect your appliance from the electricity supply before carrying out
any work on it.
Cleaning the appliance
! Do not use abrasive or corrosive detergents such as stain removers, anti-rust
products, powder detergents or sponges with abrasive surfaces: these may
scratch the surface beyond repair.
! Never use steam cleaners or pressure cleaners on the appliance.
• It is usually enough to wash the hob with a damp sponge and dry it with
absorbent kitchen roll.
warm water and soap and any burnt-on substances removed.
The burner caps should NOT be put in the dishwasher to prevent dulling
of the aluminum part
• For hobs which ligth automatically, the terminal part of the electronic instant
should be checked for blockages.
• Before using the hob, the surface must be cleaned, using a damp cloth
to remove dust or food residues. The hob surface should be cleaned
regularly with a soultion of warm water and a non-abrasive detergent.
• Stainless steel can be marked by hard water that has been left on the
surface for a long time, or by aggressive detergents containing phosphorus.
After cleaning, rinse and dry any remaining drops of water.
!
Gas tap maintenance
the tap must be replaced.
!
by the manufacturer.
24
.

Troubleshooting

It may happen that the appliance does not function properly or at all. Before
calling the service centre for assistance, check if anything can be done. First,
check to see that there are no interruptions in the gas and electrical supplies,
and, in particular, that the gas valves for the mains are open.
Check whether:
• The gas holes on the burner are clogged.
• All the movable parts that make up the burner are mounted correctly.
• There are draughts near the appliance.
Check to make sure that:
• The gas holes are not blocked in the area corresponding to the safety
device.
The burner does not remain lit when set to minimum.
Check to make sure that:
• The gas holes are not blocked.
• There are no draughts near the appliance.
• The minimum setting has been adjusted properly.
The cookware is unstable.
Check to make sure that:
• The cookware is positioned correctly at the centre of the burner.
• The pan support grids have been positioned correctly.