Wren V5BT Guía De Preparación página 4

Pairing with your V5BT
Pairing occurs when two Bluetooth devices "communicate" with each other and create a
connection. The Wren V5BT can "remember" the last six Bluetooth devices that have
paired with it. For best results, have your Bluetooth source device near your V5BT.
Note: Your V5BT will automatically enter pairing mode the first time you plug it in. The following
directions are for all subsequent pairings. If you are setting up the speaker for the first time, start
with step 3 below.
Make sure your Bluetooth source
device and the V5BT are both
turned on and the Bluetooth
mode is selected as the source
on your V5BT.
Press the setup button on the
rear of your V5BT until
(Figure 1)
the Bluetooth source indicator
blinks amber once every second
. This will place the
(Figure 2)
V5BT into « discoverable »
mode.
6
All manuals and user guides at all-guides.com
In the Bluetooth control section
of your source device, place the
source device into « discovery »
mode. « Wren Speaker » should
appear on the list of devices that
can be paired.
blinking
amber
Figure 1 Figure 2
Select "Wren Speaker." If
your source device asks for a
passkey, enter "0000" (four
zeros) and press "OK." The
Bluetooth indicator on the
V5BT will blink amber two
times per second when pairing
is in progress .
(Figure 3)
A message will appear on
your source device to indicate
when pairing is complete,
In addition, the Bluetooth
indicator on the V5BT will go
from blinking amber to solid
white . You are now
(Figure 4)
ready to play music wirelessly
on your V5BT.
Figure 3 • Pairing
Problem connecting? Visit wrensound.com/support for additional help.
To play music on your
Wren V5BT, make sure that
Bluetooth is turned on and
the "Wren Speaker" has
been selected on your source
device. Then simply select
your favorite music on your
device and play.
blinking
solid
amber
white
Figure 4 • Connected
7