Features; Accessory Items; Before Use; Cabinet Maintenance - Pioneer S-VW02 Manual De Instrucciones

FEATURES

• 100 W power that serves video software playback such
as Dolby* Digital with a wide dynamic range.
• An input that connects to the SUBWOOFER PRE-OUT
terminal
Manufactured under license from Dolby Laboratories. "Dolby"
and the double-D symbol are trademarks of Dolby
Laboratories. Confidential unpublished works. © 1992-1997
Dolby Laboratories. All rights reserved.

ACCESSORY ITEMS

RCA plug cord x 1
Non-slip pads (1x4)
(Stick one non-slip pad in each corner of the underside of
the subwoofer.)
Power cord
4
En

BEFORE USE

• Thank you for buying this Pioneer product.
• Please read this operating guide through before using
your speaker system so you will know how to optimize
performance. After you have finished reading the
operating guide, store it in a safe place for future
reference.
• The nominal impedance of this speaker system is 6 Ω.
Connect the speaker system to a stereo amplifier with a
load impedance ranging from 4 to 16 ohms (a model with
"4 – 16 Ω" displayed on the speaker output terminals).
• In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
• Do not supply power to the speaker system in excess of
the maximum permissible input.
• When connecting or disconnecting pin-plugs, be sure
amplifier power is OFF.
• When using a graphic equalizer to emphasize loud
sounds over a high-frequency range, do not use
excessive amplifier volume.
• Do not try to force a low-powered amplifier to produce
loud volumes of sound (the amplifier's harmonic
distortion will be increased, and you may damage the
speaker).
• Do not touch the speaker cone's reverberating surfaces
as they may be damaged by external force.
This Subwoofer are magnetically shielded.
However,depending on the installation location,color
distortion may occur if the speaker system is installed
extremely close to the screen off a television set.
If this happenscase,turn of the power switch of the
television set OFF,and turn it on after 15 to 30
minutes.If the problem persists,place the speaker
system away from the television set.

CABINET MAINTENANCE

• Use a polishing cloth or dry cloth to wipe off dust and
dirt.
• When the cabinet is very dirty, clean with a soft cloth
dipped in some neutral cleanser diluted five or six times
with water, and then wipe again with a dry cloth. Do not
use furniture wax or cleaners.
• Never use thinners, benzine, insecticide sprays and
other chemicals on or near the cabinets, since these will
corrode the surfaces.