Vision TECHCONNECT IR Manual De Instrucciones página 4

All manuals and user guides at all-guides.com
PLACE OF INSTALLATION
Avoid installing your unit under the following conditions:
• Moist or humid places
• Places exposed to direct sunlight or close to heating equipment
• Extremely cold locations
• Places subject to excessive vibration or dust
• Poorly ventilated places
BATTERY LIFE
This product uses 2 x AAA batteries. You should get around 12 months use out of
your batteries depending on usage. If your usage is heavy we recommend Lithium
batteries to extend the life. The batteries are housed in a sealed compartment and
should remain dry. If the product is installed in a humid climate you should check the
batteries every six months to make sure they do not get damp or rust.
LIMITATIONS OF PRODUCT
This product has been tested and works with a very wide variety of data projectors,
LCD screens, and Plasma screens. Some display products use different IR code
standards, so we do not guarantee this control module will control all available
display products. Many motorized projection screens use different codes and
therefore cannot be controlled by this product.
MODULAR BUTTONS INCLUDED
PACkAGING
Save all packing material. It is essential for shipping in the event the unit ever
needs repair.
IF ORIGINAL PACKAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE
CENTRE, DAMAGE IN TRANSIT WILL NOT BE COVERED BY WARRANTY.
2
1. VOLUME Button
2. PC/VIDEO Button
3. POWER Button
4. PC1/2/
VID1/2 Button
5. ON/OFF Button
6. SOURCE panel
7. BLANK panel
8. PC2 / VID2 Button
9. PC1 / VID1 Button