Installation; Take Out Screw Before Installation - B52 marine BMC 1012 Manual Del Propietário

All manuals and user guides at all-guides.com

INSTALLATION

Notes:
· The unit can be installed on the vehicle or the ships.
· Choose the mounting location where the unit will not interfere with the normal driving function
of the driver.
· Before finally installing the unit, connect the wiring temporarily and make sure it is all
connected up properly and the unit and the system work properly.
· Use only the parts included with the unit to ensure proper installation. The use of unauthorized
parts can cause malfunctions.
· Consult with your nearest dealer if installation requires the drilling of holes or other
modifications of the vehicle.
· Install the unit where it does not get in the driver's way and cannot injure the passenger if there
is a sudden stop, like an emergency stop.
· If installation angel exceeds 30° from horizontal, the unit might not give its optimum
performance.
0
30
· Avoid installing the unit where it would be subject to high temperature, such as from direct
sunlight, or from hot air, from the heater, or where it would be subject to dust, dirt or excessive
vibration.

TAKE OUT SCREW BEFORE INSTALLATION

Before install the unit, please remove the two screws.
Take out screw
before installation.
NOTE: If this unit is installed on the ship, you can use two pieces of plastic film to seal the two
holes after remove the screws. And this will be waterproof.
3