User Operations - GBC B1 Manual De Instrucciones De Operación

4. USER OPERATIONS

i. Interchanging Die Sets:
Are completed without tools and only take seconds to perform
ii. Punch Chip Container:
Easy-to-access chip tray for quick chip disposal
iii. Die Set Storage:
Holds up to 2 spare Die Sets
iv. Punch Bypass:
Short straight-through paper path for unpunched documents
v. Punch Mode Path:
Wide radius turn can support stocks up to 300g/m
Paper flow and User Interactive sections of MFPP-B1
Multi Function Professional Puncher – B1
2
cover
A. Interchanging Die Sets:
Your MFPP-B1 offers the convenience of interchangeable die sets,
allowing you to economically punch documents for a wide variety of
binding styles. Changing the machine's die sets is both quick and easy,
as the following instructions illustrate:
Note: For advanced Die Set Configuration instructions - See Section 8
Die Set User Manual.
Removing Die Sets from the Machine: The inter-changeable die set
slot of the MFPP-B1 is located above the bypass section of the machine.
Step 1: Stop the printer/copier.
Step 2: Open the MFPP-B1 access door panel.
Step 3: Securely grasp the die lock handle and rotate it in the CCW
direction, as indicated in the label near the die lock handle. This
releases the die from the locked position.
Step 4: Slide the die set out until it is fully removed, supporting it
with both hands.
Step 5: Properly store the removed Die Set in the Die Set storage
area of the MFPP-B1 (keep away from dust, dirt, accidental falls
from the edge of counters, etc.).
Step 6: Select the desired Die Set for your new job and slide it into
the Die Set slot. Push the Die set firmly until the Die stop feature
contacts the round magnet. This is critical in ensuring the proper
position of the punch die set.
Step 7: Grasp the handle and rotate it in CW direction until the latch
is fully engaged, as shown indicated in the label.
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING DIE SETS IN YOUR MFPP-B1, ALWAYS KEEP
FINGERS AND OTHER BODY PARTS OUT OF THE
MACHINE'S DIE SET SLOT AND AWAY FROM ALL AREAS
OF THE DIE SET, EXCEPT FOR THE FINGER HOLE IN THE
DIE SET. FAILURE TO FOLLOW THESE PRECAUTIONS
MAY RESULT IN INJURY.
Step 8: Close the Access Door Panel.
Step 9: Proceed with your printing and punching/creasing job.
Please note that when using a new die some oil will be present around
the punched holes on the sheet. After punching 25 to 50 sheets the die
will no longer leave oil on the sheets. It is recommended that a short test
print job be run after installing a new die or a die that has recently been
oiled.
B. Punch Chip Container:
The Punch Chip Container for your MFPP-B1 is located at the front of
the machine's base. The drawer should periodically be pulled out and
emptied. The MFPP-B1 uses a sensor to determine when the punch
container is full. Once the punch container becomes full the LCD display
shows "Chip Tray Full" message and a message also appear on the
printers user interface screen.
EN
6