Using The Appliance; First Use - Hotpoint Ariston MSZ 801 D/HA Instrucciones De Uso

imp. HA 21-40 INDESIT 4 GB

Using the appliance

First use

GB
Connect the appliance to the water system and
power supply (refer to the Installation manual).
When connecting the appliance to the power supply,
the display will show the temperatures preset by the
manufacturer.
Note: Reaching the preset temperatures requires a
variable amount of time. This time depends on several
factors (times the door is open, amount of food stored,
ambient temperature). Average time is between 2
to 3 hours.
30
19-09-2007 18:23 Pagina 30
Guide to selecting functions
Stand-by
This function turns off the refrigerator and freezer
compartments. To activate the Stand-by
press the Stand-by button on the left of the freezer
controls for 3 seconds: both displays will go off and a
dash will appear on the left display. To reset the
function, carry out the same procedure until the
previously set temperatures are displayed.
Note: Remember that this operation does not
disconnect the appliance from the power supply.
Freezer temperature
The factory-set ideal temperature is -18°C. As soon as
the freezer compartment reaches the required
temperature, it is automatically displayed.
To change the temperature, press the
until the display shows the required value.
Refrigerator temperature
The factory-set ideal temperature is +5°C.
To change the temperature, press the
until reaching the required value that it will be
displayed.
function,
buttons
buttons