Preparing Fox For Use; Installing The 9V Battery; Turning On/Turning Off Of Fox; Connecting T1 And T2 Temperature Probes - Salvador Escoda Fox Instrucciones De Uso Y Mantenimiento

All manuals and user guides at all-guides.com
3

PREPARING FOX FOR USE

WARNING
The presence of the synoptic sticker does not exempt the user from reading carefully this
user's manual and from observing the illustrated procedures.

3.1 Installing the 9v battery

A 9V battery is supplied in the FOX packaging. Before effecting any operation, it is neces-
sary to install the battery inside the instrument. Please proceed as follows:
Remove the screw from the battery space.
Remove the battery cover.
Place the battery inside the space taking care to connect the connector
Close the cover and fix it with the screw again.
IMPORTANT
When the battery is run down, the message "batt" will blink on the display alternating with
the selected refrigerant. When the lowest possible voltage level is reached, the instrument
will turn off automatically.

3.2 Turning on/Turning off of FOX

To turn FOX on, keep the central key pressed for more than 1 second. The display will resu-
me the operator's latest settings.
To turn FOX off, keep the central key pressed for more than 3 seconds.

3.3 Connecting T1 and T2 temperature probes

In the package, there are 2 temperature probes (type K thermocouple) that must be con-
nected before use (see picture below)
Connect them in the special spaces (check the thermocouples polarity), wait a few secon-
ds for the correct temperature value to appear on the display. The absence of connection
of the thermocouples is indicated on the display by the symbol "- - -".
Connecting
temperature probes

3.4 Connecting FOX to the system

Connect the blue hose to the LOW connection
Connect the red hose to the HIGH connection
Connect the 2 yellow hoses to the VAC and REF connections
7