Eco-De ECO-802 2021 Manual Del Usuario página 35

ASSEMBLY PRODUCT
The product comes in an advanced state of assembly; after opening the packaging the
only assembly operations consist in the fixing of the supporting feet and the pedals.
• Position the main body K to the ground and proceed to the assembly using the mul-
ti-purpose key and hex wrench inside the packaging.
• Mount the rear support bar B in the back of the main body, below the power switch,
and then secure it on one side with two screws I (M8x75 mm) accompanied by H flat
washers (M8) and on the other side with two self-locking nuts J (M8) accompanied by
H flat washers (M8), tightening them using the Allen key F and multiple key E.
• Mount the front supporting bar at the front of the tool, then secure it on one side
with two screws I (M8x75 mm) accompanied by H flat washers (M8) and on the other
side with two self-locking nuts J (M8) accompanied by H flat washers (M8), tightening
them using the Allen key F and multiple key E.