Replacing Batteries - bbluv Ora Manual De Instrucciones

4. Point the thermometer probe to the center of the object, about 1 to 3 cm
(0.4 to 1.2 in) away from the object surface.
5. Press and release the Measure button
displayed on the screen instantly.
6. If no activity is detected, the thermometer will power off automatically
in 10 seconds.

REPLACING BATTERIES

1. Slide the battery cover
off along the marked
direction and take it off.
2. Insert the two AAA batteries
into the compartment
according to the stated
polarities.
NOTE:
(1) Make sure that the batteries are installed correctly. Otherwise, the termometer might get damages.
(2) If the low-battery symbol appears on the screen, replace the batteries.
(3) Make sure you replace the batteries with the same type of batteries.
CLEANING & MAINTENANCE
CLEANING YOUR ORÄ
1. Take the batteries out before cleaning.
2. Clean the probe
probe with a cotton swab.
3. Wipe the thermometer body with a slightly damp soft cloth.
Keep water out off the lens sensor during the cleaning process otherwise
you could damage the lens. The lens might get scratched if it is not
cleaned properly, which might cause inacurate readings.
Do not clean the termometer with corrosive cleansers. During the
cleaning process, do not immerse any part of the thermometer into
liquid, or allow any liquid to penetrate the thermometer.
Recommended cleaning product:
• Medical cleaners
• Mild soap
I
C
with a soft cloth. Clean the lens of the temperature
B
. The temperature reading will be
Orä
EN
11