Backlight - Velleman WT11EL Guia De Inicio Rapido

Press the ALARM ON/OFF button repeatedly when the device is in the normal display mode if you want to arm or
disarm ALARM 1 and/or ALARM 2. Press ALARM ON/OFF once to arm ALARM 1 only (
appears on the display)
and press again to arm ALARM 2 only ( is displayed). Press a third time to arm both ALARM 1 and ALARM 2 (
and are displayed) and press a fourth time to disarm both ALARM 1 and ALARM 2 ( and are erased). Press
a fifth time to arm ALARM 1 only, etc...
Note that the alarm icon flashes while alarm 1 is sounding and alarm icon flashes while alarm 2 is sounding.
Press ALARM ON/OFF to stop the alarm.
Press LIGHT/SNOOZE to activate the snooze function. The snooze symbol (
) flashes on the display until the
alarm is reactivated 4 minutes later.
7. "Local Time" (
)
You may live in a different time zone from that of Frankfurt even though your residence is still within reach of the
atomic clock there. If so, the time display will automatically change to Frankfurt time when the DCF signal is received.
You can then set the "foreign time" as your own local time :
Make sure the temperature is displayed in the lower right-hand corner of the display. Hold the + button for 3 seconds
symbol appears. Hold MODE for three seconds until the digits for the hours start to flash. Set the hours
until the
with + or – and confirm with MODE.
Hold + for 3 seconds if you want to return to the normal display mode.
8. Additional Time Zone
You can keep track of the time in a different time zone by setting the clock accordingly in dual time mode. Press
MODE three times in the normal display mode to display DUAL TIME in the bottom right-hand corner of the display.
Then hold MODE for 3 seconds until the digits for the hours start to flash. Enter the hours with + and – and confirm
with MODE. The digits for the minutes start to flash. Enter the minutes with + and – and confirm with MODE.
Press MODE one more time to return to the normal display mode.
9. Projector
Press the LIGHT/SNOOZE button once to activate the projector for ± 5 seconds.

10. Backlight

Press the LIGHT/SNOOZE button once to activate the backlight for ± 5 seconds. Connect the device with the mains
via the included adapter (230Vac/50Hz, DC3V, 100mA) and slide the CONTINUE PROJECTION switch on the side
of the housing to the right for continuous projection. Adjust the focus of the projection with the FOCUS adjustment at
the back. Press the FLIP button at the back to turn the projection 180° clockwise. You can also rotate the projection
manually with the ROTATE adjustment at the back.
11. Temperature Display
Press the °C/°F button in the normal display mode to display the temperature either in °C or °F.
12. Time Display Mode
Press the + button in the normal display mode to display the time either in 12hr- or 24hr-mode.
WT11EL VELLEMAN
3