Cleaning And Maintenance; Appliance Front And Control Panel; Interior Of The Warming Drawer; Mat With Non-Slip Surface - Kuppersbusch WS 6014 Instrucciones De Uso E Instrucciones De Montaje

Cleaning and Maintenance

Cleaning is the only maintenance action that is
required normally.
Warning! Cleaning must be done with the
warming drawer
electrical power supply. Remove the plug from
the power socket or disconnect the warming
drawer power supply circuit.
Do not use aggressive or abrasive cleaning
products, abrasive
objects since stains or abrasion marks may
appear.
Do not use high pressure or steam jet
cleaning appliances.

Appliance front and control panel

The warming drawer can be cleaned using just a
damp cloth. If it is very dirty, add a few drops of
washing-up liquid to the washing water.
Wipe the surfaces dry using a dry cloth.
For stainless steel fronted warming drawers,
special products for treatment of stainless steel
surfaces can be used. These products prevent
the surfaces becoming dirty again for some time.
Apply a thin layer of such a product on the
surface using a soft cloth.
On aluminium fronted warming drawers use a
gentle glass cleaning product and a soft cloth that
does not release fluff. Wipe horizontally without
pressing on the surface since aluminium is
sensitive to scratches and cuts.
disconnected from
sponges or

Interior of the warming drawer

Clean the inside of the warming drawer regularly
using a damp cloth. If it is very dirty add a few
the
drops of washing-up liquid to the washing water.
Wipe the surfaces dry using a dry cloth.
Avoid water entering through the air circulation
opening.
pointed
Only use the warming drawer again when it is
completely dry.

Mat with non-slip surface

The non-slip surface mat can be removed to
facilitate cleaning of the drawer.
The mat can be cleaned by hand using hot water
with a few drops of washing-up liquid.
Dry thoroughly.
The non-slip mat should only be replaced when it
is completely dry.
EN
21