How To Install The Fence - Gallagher PowerPlus M1800 Instrucciones

HOW TO INSTALL THE FENCE

1. Plan the fence line. Avoid rough, stony or steep areas if possible. For best electric fence performance use
multi-wire (at least 3 wires connected in parallel) fenc ing.
2. Install end strain posts and corner posts. Ensure that all corner posts are well installed to withstand the wire
strain.
3. Run out the bottom wire between the end posts.
4. Tension wires until there is only a slight visible sag.
5. Connect all live wires in parallel at the end of each fence section using Joint Clamps G6030.
Use Joint Clamps G6030 to ensure tight wire connections. Connect any earth wires together
in parallel. Never connect live and earth wires together.
6. Conduct the fence system under gateways, rather than overhead. Do not use electric gates to
get power across gateways. Install Lead-out Cable G6270 in a plastic pipe (for physical
protection), 30cm (12") deep. Turn the ends of the pipe down to keep water out. Connect each
end of the cable to the Joint Clamps.
ALL HOT WIRE SYSTEM
Cut-out Switch
LIVE CABLE
12" (300mm) deep
Offset Fence
Existing non-electric fences can be protected to last for many more years simply by attaching Offset Brackets (G6590
or G6620) and an electrified wire on one or both sides of the non-electric fence. Use a single offset wire, po si tioned
at two thirds the height of the animal (chest height) to be controlled.
HANDY HINT
Use Cut-out Switches (G6076) to allow sections of the fence system to be switched off
during fence maintenance. Put a switch at each gateway and at every major change in fence
direction.
When joining wires under tension, use a figure eight or reef knot.
Do not use copper wire anywhere in your fence system.
8
Gallagher 3E1936 PowerPlus Mains Powered Energizer User Manual
Fence di rec tion
Cross Bar
G6781 Strain Insulator
G6430
3m
(10ft)
Joint Clamps
HOT
HOT
HOT
EARTH WIRE RETURN SYS TEM
Cut-out Switch
LIVE CABLE
EARTH CABLE
G6030
Joint Clamps
HOT
EARTH
HOT