Defiant MSH27920DLWDF Guía De Uso Y Cuidado página 10

troubleshooting (continued)
Problem
□
Light stays ON at There is motion in the
night and does detection zone.
not turn OFF.
□
Unit is in override mode
(if there is no motion).
□
Unit is in the "Auto" mode.
□
Light The light given from the unit's
continuously own lamp is affecting the
blinks ON and motion sensor.
OFF at night.
□
The knob is positioned between
TEST and 1m.
□
Light is on The controls on the bottom of
during the day. the motion sensor are in the
TEST mode.
□
The motion detector is
shadowed.
□
Red LED indicator During daylight hours, the
light comes ON red LED indicator will flash
and OFF during when motion is detected. This
daylight hours. is normal.
□
Cannot activate Surrounding external ambient
dusk to dawn light is too bright. (If so, the
mode at night unit may think it is daytime.)
(override)
□
Not enough time is allowed to
enter the dusk to dawn mode.
□
There is more than one fixture
on an indoor wall switch.
Possible Cause
10
Solution
□
Make sure the sensor is not picking up moving
objects such as trees, traffic, etc.
□
Reduce the sensitivity.
□
Reposition the motion sensor.
□
Turn the light switch to the OFF position for 90
seconds, and then turn back to the ON postion.
This will send the unit back into the motion
activated setting "Auto".
□ If the light stays on with the sensor lens
covered, contact Customer Service.
□
Make sure the unit is set between 1m-12m
("Auto" mode).
□
Re-aim the lamp.
□
Reposition the motion sensor.
□
Reposition the knob closer to the selected
function—either TEST or 1m.
□
Reposition MODE knob off of TEST to a time
selection (1m-12m).
□
Reposition motion sensor.
□
No corrective action is necessary.
□
Re-aim the sensor head.
□
Relocate or reposition the unit away from
the light.
□
Turn power OFF and ON twice within 3 seconds.
□
If so, put them on separate switches.