Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
LOCAL INSTALLATION
REGULATIONS
This appliance must be installed in accordance with
local codes or, in the absence of local codes, the
National Fuel Gas Code, ANSI Z223.1/NFPA 54 or
the Natural Gas and Propane Installation Code, CSA
B149.1. Not for Installation in a Manufactured Home
(Mobile Home).
LOCATION
The water heater should be installed indoors, in a
dry, level area where the tank and water lines are
protected from freezing temperatures. If needed,
shims can be used under the base of the unit to
level it.
All water heaters are subject to leaking, due to the
corrosive properties of water over time. The water
heater should be located in an area where leakage
of the tank or connections will not result in damage
to the area adjacent of the appliance or to lower
floors of the structure. When such locations cannot
be avoided, it is recommended that a suitable drain
pan, adequately drained, be installed under the
appliance. A ground floor or basement installation is
suggested. Inspect and maintain the water heater
according to this manual to minimize the potential
for leakage.
Catch Pan Installation (If Required)
Catch Pan
NOTE: The auxiliary catch pan MUST conform
to local codes. Catch Pan Kits are available from
the store where the water heater was purchased
or GEApplianceparts.com. The catch pan outer
diameter (OD) should be 3" (7.62 cm) minimum
larger than the Water Heater base diameter. The
pan must not restrict combustion air flow.
14
LOCATION (Cont.)
The installation must allow sufficient airflow for
combustion and ventilation, and should be as close to
a gas vent or chimney as possible. Avoid areas where
the water heater could be exposed to flammable
liquids and vapors or a corrosive atmosphere.
The water heater can be installed on combustible
flooring, but not directly on carpet. If the water heater
must be located in a carpeted area, install a wood or
metal panel as a barrier between the water heater
and carpet; the panel should be 3" larger than the
water heater in all directions.
To minimize thermal loss, the water heater should
be close to the areas of greatest demand. Insulated
water lines also help to maintain optimal temperatures
from water heater to faucet.
The installation must allow sufficient access to the
top, front and sides of the water heater for service.
Moving the water heater for service is not covered
under the warranty.
For installation requiring earthquake straps, minimal
clearance around the sides of the water heater is
acceptable. In this case, additional clearance should
be provided on the opposite side of the unit to allow
for service access. Refer to For Installations in the
State of California, page 4.
LOCATION
Relief Valve
Pipe
INSTALLATION and SERVICE ACCESS
LOCATION
ALCOVE
CLOSET
Catch Pan
Drain
Refer to the rating plate beside the gas control/
thermostat on the front of the water heater for further
details.
Minimum Clearances from
COMBUSTIBLE CONSTRUCTION
FRONT
SIDES
CONTROL
ALCOVE
3"
0"
CLOSET
3"
0"
Minimum Clearances for
FRONT
TOP
SIDES
BACK
CONTROL
COVER
24"
0"
0"
24"
24"
0"
0"
24"
TOP
BACK
COVER
0"
12"
0"
12"
COMBUSTION
T&P RELIEF
AIR INLETS
VALVE
1"
1.5"
1"
1.5"
49-6000245 Rev. 2
Publicidad
Tabla de contenido
