Uline ADA HEX H-6575 Manual Del Usuario

H-6575
ADA HEX PICNIC TABLE
TOOLS NEEDED
7/16" (11 mm) Socket Bit
Power Drill (Or Screw Gun)
5 Gallon Bucket (Optional)
Half Base x 2
Tabletop x 1
NOTE: It is important to keep screws loose
throughout assembly. Tighten during step 11.
1. Verify all parts are present before beginning.
May contain extra hardware.
2. Loosely attach the four leg anchor blocks to the
bottom of the four seats using the 3½" lag screws,
washers, power drill and 7/16" socket bit (will tighten
later in step 11). The bored hole on the leg anchor
block faces the side with three edges. (See Figure 1)
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Tape Measure
Two Person Assembly
Recommended
Full Base x 1
Support Arm x 3
PARTS
Left Seat x 2
2½" Lag Screw 3½" Lag Screw
x 6
ASSEMBLY
3. Place the three support arms on a flat level surface
in a fan pattern. Using the 3" drywall screws, loosely
attach the support arms together (will tighten later in
step 11). Use two drywall screws per side.
(See Figure 2)
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Right Seat x 2
Leg Anchor Block x 4
3" Drywall Screw
x 26 x 9
Washer x 32
0622 IH-6575