Uline ADA HEX H-6575 Manual Del Usuario página 2

4. Loosely attach the seat to the support arms with eight
of the 3½" lag screws and eight washers through the
pre-drilled holes using the power drill and 7/16" socket
bit (will tighten later in step 11). (See Figure 3)
NOTE: The two slightly shorter seats should be
attached to the same support arm.
Figure 3
5. Position the seat assembly approximately 10-15" off
the floor. A five gallon bucket under the center works
well. (See Figure 4)
Figure 4
6. Twist center supports of base and half base so they
are flush with bottom boards. Insert 3" drywall screw
into pre-drilled hole through bottom board.
(See Figure 5)
Figure 5
Half Base
7. Insert the three bases under each set of seats.
Center each leg to the counter-bored holes in the
seat. The full base goes under the support arm with
two seats. (See Figure 6)
Figure 6
PAGE 2 OF 6
ASSEMBLY CONTINUED
8. Use the 2½" lag screws to loosely attach bases to
the seats (will tighten later in step 11). Use a tape
measure to ensure that seats are centered and
2" from base. Make sure the seats are pressed flat
against the base. (See Figure 7)
9. Place the tabletop on top of table to align with the
holes of the bases. Make sure the support arms are
centered. (See Figure 8)
10. Loosely attach each base to the tabletop and
support arms using the 3½" lag screws and washers
with the power drill and 7/16" socket bit (will tighten
later in step 11).
11. Make sure the table is squared and tighten all lag
and drywall screws.
Full Base
1-800-295-5510
uline.com
Figure 7
Figure 8
Centered
Support
Arms
WARNING! Do not lean on tabletop or seats
when assembling.
NOTE: H-6681 Mounting hardware sold
separately.
0622 IH-6575