Zeiss SYCOP 3 Manual Breve página 12

ZEISS
Fig. 3 Initialization Screen on the
Touchscreen
Fig. 4 Stage Initialization Query Window
Fig. 5 'Home' Home Page (System
Unconfigured)
10
SWITCHING ON SAFELY
10
Check that the microscope system has been
correctly set up and connected.
All transport locks are properly removed.
Switch on all the light sources and illuminators
existing in the system. In so doing, follow the
separate operating instructions of each device.
Now, all components can be switched on
according to the operating manual of the main
device.
• Before switching the device on, check that the
joystick on the SYCOP 3 is in zero position and
that the footswitch, if any, is freely accessible.
• Set the Power switch at the back of the EMS 3
controller to position I. If necessary, briefly press
the
3 controller.
The system will be switched on and will initialize
(Fig. 3).
If a motorized stage is connected, a stage
initialization query will appear (Fig. 4).
If the
−
will be performed immediately.
If the
−
will be stopped and may be carried out later.
When the initialization is completed, the Home
home page (Fig. 5) will appear.
The system is ready for subsequent configuration.
Further
parameters can be found in the main operating
manual.
435611-6044-008
SWITCHING ON SAFELY
button (standby) on the front of the EMS
button is pressed, initialization
button is pressed, initialization
options for setting
SYCOP 3
user-dependent
09/2017