JOCCA Style 1574 Manual De Instrucciones página 7

SILICONE HEAD
Silicone material, soft and gentle texture, fits closely to
the skin, easily copes with clean dead corners, cleans
pores, and brightens skin tone.
BRUSH HEAD
Brush head, soft cleansing, fine brush close to the skin,
soft and not hurting the skin, cleans pores, blackheads,
and oil.
MASSAGE HEAD
Steel massage head, instead of traditional plastic ball
bearings, steel ball head applies to the whole body
which can use for no dead angle massage and lift the skin.
2.Press the button
begin to rotate.
3.You have two speeds to choose. To increase the speed, press the button
again.
Is recommended to test it first at a low level for the first cleaning
APPLICATION METHOD
-First, wet the face with warm water, then wet the brush head, apply an
appropriate amount of cleanser and proceed to facial cleansing.
-Wash your face with lukewarm water and pat your skin dry with a soft
towel.
-It can be replaced by the silicone head, or the steel ball massage head,
depending on the type of cleaning or massage desired.
Note: when you replace the brush head, pull up horizontally
-After power on, it will automatically power off after being used for more
than 4 minutes in any working state with sufficient power.
CLEANING AND STORAGE
-Do not use abrasive detergents or products that could damage the
appliance. Simply clean the surface with a wet cloth.
-DO NOT IMMERSE THE APPLIANCE IN WATER OR ANY OTHER LIQUID.
-After use, turn off the appliance and remove the head, note that the
main frame of the apploance should not be immersed in water.
-The accessories can be washed with water, as long as it does not exceed
50ºC. After cleaning, allow to air dry.
-Regular cleaning of accessories helps to extend the service life.
, the green light will turn on, and the head will
English
EN
7