Installing The Chargepak F1 - PURE Sensia 200D Connect Manual De Instrucciones

Installing the ChargePAK F1

1. Switch Sensia 200D Connect off and disconnect from the mains power supply.
2. Open the battery compartment.
3. Position ChargePAK so that the contacts are facing the battery compartment and the tab is at the top
and insert ChargePAK into the battery compartment.
4. Replace the battery cover and connect your product to a power supply.
5. ChargePAK will begin charging.
Note: When charging your ChargePAK for the first time or after an extended period of inactivity it is
recommended that it is charged for around 24 hours to ensure full battery power. If ChargePAK is
completely flat, there may be a slight delay before the battery charging indicator is displayed.
Note: It is normal for your ChargePAK to get warm, especially during charging. Your ChargePAK will give
years of trouble-free use under normal circumstances, but like all rechargeable batteries its efficiency will
gradually reduce with age.
Important: Sensia 200D Connect can only be powered with a Pure ChargePAK F1 and is not compatible
with any other batteries, either disposable or rechargeable, or any other ChargePAK model.
24
All manuals and user guides at all-guides.com