Display And Operating Keys - Kroeplin F102 Manual De Instrucciones

2. Display and operating keys

Display:
No. Display Function
Without Continuous tracking of the
measured value and
pointer in relation to the
position of the caliper
1 REL Switching from Absolute
into Relative mode.
(0-Preset)
The Absolute mode will
not be displayed sepa-
rately
2 MIN Finding and saving of the
minimum measured value
Requirement:
Measuring axle is central
to the bore
3 MAX Finding and saving of the
maximum measured value
Requirement:
Measuring axle is vertical
to the bore
Application
Absolut mode: Direct finding and reading of the measured value
Switch can be done in every mode,
but should be done in MIN, MAX or HOLD Mode, as the last measured
value can be set to 0.
For internal diameter and wide grooves,
Steadily pivot gauge vertically
Measurement:
Measured value
too high
For small grooves where a vertical panning is not possible.
Steadily pivot gauge horizontally or turn it around its own axis.
Measurement:
Measured value
too small
16
Measured value
is correct
Measured value Measured value
is correct
Measured value
too high
too small