Honeywell Home R200H-N1 Instalación Y Guía De Usuario página 8

9. Visual & acoustic signals
Operating mode
Normal
Test
Alarm for heat
Alarm silence
Low battery warning
Low battery/Sensor fault
warning silence
Sensor fault warning
Interconnected alarm
End of life warning
Wireless interconnecting
Alarm/Low
battery/Sensor fault
silence
If the alarm fails to operate, the advice of the manufacturer should be sought.
Note: If the heat alarm is activated for more than 30 minutes, the frequency of the heat alarm will be
slow down to every 24 seconds, and frequency of interconnected alarms will be reduced to 6 minutes'
interval.
10. Wireless functions
Interconnect your alarms
a) Place the interconnected alarms as close as possible, not further than 5 meters apart.
b) Choose one interconnected alarm as Master. Press 3 times its test/silence button. The LED light will
turn on.
c) Choose another interconnected alarm as Slave. Press 3 times its test/silence button. The LED light will
turn on.
Visual signal(flash)
1 x per 48 seconds
1 x per second (4 x)
1 x per second (4 x)
1 x per 8 seconds
2 x per 48 seconds
1 x per 48 seconds
2 x per 48 seconds
None
3 x per 48 seconds
Continuously on
HOW TO MUTE ALARMSOUND
ONLY AFTER RECOMMENDED ACTIONS HAVE BEEN
TAKEN
(see page 5)
Acoustic signal(beep)
None
1 x per second (3 x) /
pause of 1,5 seconds
1 x per second (3 x) /
pause of 1,5 seconds
None
1 x per 48 seconds
None
None
1 x per second (3 x) /
pause of 1,5 seconds
3 x per 48 seconds
None
-8-
Description
Device is functioning properly
Device is testing by press the
test/silence button for 3 seconds
Device is detecting heat
If Alarm signal is muted, lasting for
approx.. 10 minutes
Battery is running low
If Low battery/Sensor fault warning
is muted, lasting for approx. 8-10
hours
Sensor is not functioning properly
Device received remote alarm from
other device.
Device is end of life
Device is sending or searching for
wireless signal
Press cover test/silence button for
3 seconds