GRAPHITE 56H100 Manual De Uso página 12

To fold, follow the procedure in the reverse order (Fig. B).
Be particularly careful while folding and unfolding the stand. If you are not careful, edges and
moving parts may injure or crush your fingers.
ASSEMBLY AND DISASSEMBLY OF SUPPORTS WITH LIMIT STOP
Assembly of supports with the limit stop (Fig. C, D)
●
Carry out the work when the stand is unfolded.
●
Unlock the extension arm with the extension arm locating wheel (
●
Extend the extension arm (
●
Loosen up the bolt locking the supports with the limit stop (
●
Insert the support with the limit stop into the guiding groove of the stand support beam or the groove
in the extension arm, depending on the support distance required by the material.
●
Tighten the bolt locking the supports with the limit stop (
●
Slide the extension arm towards the stand.
●
Lock the extension arm with the extension arm locating wheel (
●
Repeat the operation on the other side of the stand for the other support with the limit stop.
To disassemble the supports with the limit stop, follow the procedure in the reverse order.
ASSEMBLY AND DISASSEMBLY OF THE MITRE SAW INSTALLATION BRACKETS
Fixing the mitre saw to the mitre saw installation brackets (11).
●
To facilitate the process, you can carry out the operation when the brackets are positioned on a stable
ground or fixed to the mitre saw universal stand.
●
The installation holes must be compatible to the spacing of the holes in the mitre saw base.
●
The release levers must be arranged so that they are located at the rear part of the saw.
●
Screw the mitre saw installation brackets to the mitre saw so as to ensure that one bracket is situated to
the left of it while the other one - to the right of it.
●
The mitre saw installation brackets are fixed to the mitre saw base by means of the installation bolts
(provided in the set).
●
Depending on the design of the mitre saw, the installation bolts should be set with their heads down or
up to maintain their functionality.
To disassemble the mitre saw installation brackets, follow the procedure in the reverse order.
INSTALLATION AND DEINSTALLATION OF THE MITRE SAW ON THE STAND
Installation of the mitre saw with the installation brackets fixed to the mitre saw universal stand.
●
Raise the saw with the brackets above the stand support beam.
●
Align the saw with the support beam, tilting it to yourself to make the front concave edge of the fixing
brackets touch the front edge of the stand support beam.
●
Pull the bracket release levers (
●
Let the bracket release levers (
beam.
●
To prevent the risk of incidentally taking the saw off the stand, secure the mitre stand installation
brackets by inserting a bracket security pin (13) into each of them (Fig. E).
●
While carrying out precise works, one of the fixing brackets should be installed in the positioning catch
(10) just to ensure that the saw will not move to the left or to the right.
To remove the mitre saw from the stand, follow the procedure in the reverse order.
5).
12) away from yourself and tilt the saw to the vertical position.
12) go so that they get locked on the rear edge of the stand support
12
6).
14).
14).
6).