FONESTAR DMX-83 Manual De Instrucciones página 7

PROGRAMMING MODE
Press and hold the PROGRAM button for three seconds to activate/deactivate programming mode. The
PROGRAM LED indicator will blink constantly when the mode is active.
PROGRAMMING A SCENE
- In programming mode, select the scanners corresponding to the devices you want to program first.
- Adjust the scroll controls of each channel in accordance with your desired configuration (use the PAGE A/B
button if the device has more than 8 channels).
- If you want to program a separate scanner, turn off the scanner you have just programmed and select the
new scanner in order to adjust the scroll controls for the new item.
You can program, consecutively, as many scanners as you need.
- Select the bank where you wish to store the scene using the BANK UP and BANK DOWN buttons.
Nota: 30 different banks are available. Each bank can store 8 scenes.
- Press the ADD button.
- Press and hold the SCENES 1-8 button to store the scene at its final location. All LEDs will flash three times
indicating that programming has been completed successfully.
- Repeat the above steps to store as many scenes as you want.
- Exit programming mode. The BLACKOUT feature is automatically activated.
EDITING A SCENE
- Within programming mode, select the bank where the scene is stored using the BANK UP and BANK
DOWN buttons.
- Press the selected SCENES 1-8 button to display the scene for editing.
- Select the scanners corresponding to the devices you want to program.
- Adjust the scroll controls of each channel in accordance with your desired configuration (use the PAGE A/B
button if the device has more than 8 channels).
- Press the ADD button.
- Press and hold the SCENES 1-8 button to store the scene at its final location. All LEDs will flash three times
indicating that programming has been completed successfully.
- Repeat the above steps to modify as many scenes as you want.
- xit programming mode. The BLACKOUT feature is automatically activated.
COPY ONE SCENE TO ANOTHER SCENA
- Within programming mode, select the bank where the scene is stored using the BANK UP and BANK
DOWN buttons.
- Press the selected SCENES 1-8 button to load the values of the scene being copied.
- Select the bank where you wish to store the scene using the BANK UP and BANK DOWN buttons.
- Press the ADD button.
- Press and hold the SCENES 1-8 button to store the scene at its final location. All LEDs will flash three times
indicating that programming has been completed successfully.
- Exit programming mode. The BLACKOUT feature is automatically activated.
- 7 -
EN