Installation Instructions - INVENTOR FS403W Manual Del Propietário

INSTALLATION INSTRUCTIONS

■ Name of components
Considerate Hint:
Remove right-angle bolt
from the pole before
performing installation.
Note: The figures in
this manual are only for
explanatory purposes.
In case of discrepancies
between the illustrations and
the actual product, please
refer to the product that you
purchased.
Motor
Tighten
knob
Install by
aligning
Pole
Tighten
knob
Pole Installation
1. Remove the tighten knobs from the upper and lower
pole.
2. Align the poles using as guide the holes on the
components. Push downward the upper pole into the
hole position.
3. Lock and secure the position by tightening the knobs.
4. Insert the lower pole into the chassis and tighten the
right-angle bolt
Tip: The right-angle bolt may be placed already under the
chassis. Remove it before the installation.
Rear grill
Pole
Base
Right-angle bolt
5
ΕΝ