Technical Characteristics - Super Ego 1500000447 Instrucciones De Uso

Technical characteristics

References
Voltage
Frequency
Rated power
Diameter range
Temperature range
Compatible materials
Dimensions
Weight
Operating instructions
NOTE
Surfaces to be welded must be treated immediately
prior to welding. Protect surfaces from weather
conditions.
12
MODEL Ø 63 mm
1500000447
1500001716
1500000448
1500001717
1500002835
1500003950
1500003696
110 V 230 V
50-60 Hz / 1~ 50-60 Hz / 1~
800 W
Ø 20 - 63 mm
50 - 315 ºC Max
352 x 129 x 52 mm
1.0 kg (polyfuser only, without dies)
1. Preparing the tube
A. Cut the tube straight
across using a suitable
tool (pipe cutter or
cropper).
B. Clean the surface
to be welded and the
adapters with cellulose
tissue dampened with
isopropanol.
C. Mark the length of
the weld on the tube.
ENGLISH
1500003260 1500003308 1500000449 1500003261
127-240 V 110 V
60 Hz / 1~ 50-60 Hz / 1~ 50-60 Hz / 1~
PE, PP, PB y PVDF
1.37 kg (polyfuser only, without dies)
2. Preparing the socket welder
ATTENTION
Check the condition of the adapters from time to
time, to ensure correct welding.
A. Fix the adaptors corresponding to the
diameters of the tubes to be welded to the
heating plate. In no case they may protrude
from the periphery of the heating plate.
B. Connect the tool to the mains or power
generator. (110V or 230V)
C. Adjusting the welding temperature: press
then use the up arrow
until the desired welding temperature
3.7
is set, and press
setting. Press the ON/OFF button
switch on the heating of the appliance.
D. Wait for the temperature to reach the setting.
Approx. 7 minutes up to 260º, and some 15
minutes total time to stabilize the temperature
around the plate.
MODEL Ø110 mm
230 V 127-240 V
60 Hz / 1~
1000 W
Ø 75 - 110 mm
50 - 315 ºC Max
352 x 155 x 52 mm
and down arrow
3.6
again to confirm the
3.4
,
3.4
to
3.5