Environment; Trouble Shooting - MaxPro PROFESSIONAL MPSG550/800V Manual De Instrucciones

ENVIRONMENT

Do not dispose of electric tools, accessories and packaging together with household waste material -
in observance of European Directive 2002/96/EC on waste of electric and electronic equipment and its
implementation in accordance with national law, electric tools that have reached the end of their life must
be collected separately and returned to an environmentally compatible recycling facility.
6 GB

TROUBLE SHOOTING

Fault Symptom Possible Cause
Motor noise not normal Spray gun not clean, or not
lubricated, resulting in piston being
stuck in cylinder
Motor hums but does not spray Worn swirl head
or irregular spraying
Pick up pipe not in the right
position
Blocked pick up pipe
Blocked nozzle
Blocked filter
Control knob needs adjustment
Atomization is not good Viscosity of material too high.
Material volume too large.
Material volume setting too
high (+).
Nozzle clogged.
Air filter clogged.
Too little pressure build-up in
container.
Over painting Spray gun not clean, or not
lubricated resulting in piston being
stuck in cylinder
Too much paint
Viscosity too low
Operating sound not right Poor output adjustment
Not enough paint in the container
resulting in air being sucked in
Not diluting properly or not
passing pick up pipe completely
"Orange Skin" excessive fogging Incorrect solvent is used
Spray gun too far from the surface Hold spray gun closer to the object
Paint too thick
Little or no material flow Nozzle clogged.
Suction tube clogged.
Material volume setting
turned too low(-).
Suction tube loose.
No pressure build up in container.
Air filter clogged.
Material leaking Nozzle loose.
Nozzle worn.
Nozzle seal worn.
Material build-up on air
cap and nozzle.
Troubleshooting
Disassemble spray gun and clean
with thinner
Replace swirl head
Re-adjust pick up pipe
Clean with thinner
Clean nozzle
Clean with thinner
Adjust
Thin.
Decrease volume setting (-).
Decrease volume setting (-).
Clean.
Change.
Tighten container.
Disassemble spray gun and clean
with thinner.
Adjust the volume clockwise to
reduce spraying. Two thin
coats are better then one
Check viscosity
Re-adjust
Refill with paint
Check pick up pipe and viscosity
level
Use correct solvent
Thin the paint
Clean.
Clean.
Increase volume setting (+).
Insert.
Tighten container.
Change.
Tighten.
Replace.
Replace.
Clean.
GB
７