Components List; Technical Data - EDM Product 08700 Manual De Instrucciones

COMPONENTS LIST

1. Drill chuck
2. Second handle
3. Switch for percussion drilling/drilling
4. Direction switch
5. Locking button
6. Operating switch with speed regulator wheel
7. Depth stop

TECHNICAL DATA

Voltage
No load speed
Power
Chuck size
Drilling capacity (steel)
Drilling capacity (concrete)
Drilling capacity (wood)
FUNCTIONS
Berbequim tem as seguintes funções:
▶The operating switch (6) is used for all work carried out with the
drilling machine. With the speed selection via the regulator wheel
you have optimum control of the machine.
▶The machine can be set to continuous operation with the locking
button (5).
▶The operating switch (6) is used for all work carried out with the
drilling machine. With the speed selection via the regulator wheel
you have optimum control of the machine.
▶Depending on the position of the percussion drilling/drilling switch,
you can use your drilling machine as a percussion drill or rotating
drill.
▶The direction switch (4) controls the direction of motion when the
machine is used as a screwdriver or if you would like to remove a
Instruction manual
230-240V~50Hz
0-2600 rpm
500W
Ø13mm
10mm
13mm
25mm
1 3
2
drilling bit that has become jammed.
▶Using the adjustable bit stop you can fix the depth of blind holes
accurately during drilling.
PREPARING THE DRILLING MACHINE
Warning! When performing the following work, always
ensure that the machine is not connected to the mains
power supply.
INSERTING THE SECOND HANDLE (2)
In order to assemble the second handle (2), release it by rotating the
lower part anti-clockwise so that you can easily pull the handle over
the drill chuck on to the flange located behind it. Then turn the handle
to a working position that is comfortable for you and fix it in place by
tightening it (rotating the lower part clockwise).
13
ref. 08700
7
5
4
6
ES
PT
EN
FR