Notification for gold items will appear in the center or left of the scale on the
•
display.
•
Notification of small gold items will appear under the FOIL, NI/5¢ categories.
•
Notification of large gold items will appear in the center of the scale on the
display.
Notification of silver items will appear on the right side of the scale (DIME, QTR,
•
50¢).
•
Notification of iron objects of any size will appear on the left side of the scale
(IRON).
CAUTION!
cannot be uniquely identified until it is unearthed. The table is for general reference
only.
ILLUMINATION:
To turn on the backlight, press the BACKLIGHT button. Pressing the button again turns
the backlight off.
Caution: Since the backlight consumes more power, it is recommended to turn it off in
bright areas.
PP (PINPOINT):
When you find a metal object, you can use the PP (PINPOINT) function to determine
the precise position of the target.
1. Press the PP button to activate the PINPOINT function.
2. Slowly move the probe over the selected location. If the detector finds the
target, it will beep. The target is located where the sound is loudest.
3. Narrow down the search. Press the PP button again. Position the center of the
probe near where the detector found the target, but do not position the probe
directly over the target. Slowly move the probe over the selected location.
Now the sound will only be emitted when the coil is directly over the target.
4. Repeat the procedure in step 3 several times. After each repetition of the
procedure, the detection field will become narrower and the detector will
indicate the position of the metal target more and more precisely.
3.4.
Cleaning and maintenance
a)
Turn off the unit before each cleaning.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
After each cleaning, all the parts should be dried well before the unit is used
again.
d)
Store the unit in a dry and cool place protected from moisture and direct
sunlight.
There is a wide variety of metals. The target detected by the unit