Cleaning And Maintenance - Steinberg Systems SBS-MD-24 Manual De Instrucciones

CAUTION!
mode, a medium or high tone will be emitted.
PRECISE TARGET LOCATION
Accurately determining the location of a target makes it easier to dig.
To locate a target, you must:
1. Slowly move the probe over the selected location. If the detector finds the
target, it will beep. The target is located where the sound is loudest.
2. When the detector detects buried metal, continue moving the probe from side
to side, directly over the target, making a narrower and narrower range of
motion.
3. Remember where the detector beeps and stop the probe directly over that
point.
4. Move the search coil in a straight line away from you and back several times.
5. Repeat steps 2-4 at right angles to the original search line to make an "X" mark.
6. The target will be directly under the "X" mark at the location where the beep
will sound.
CAUTION! This method requires practice and good familiarity with the device.
3.4.

Cleaning and maintenance

a) Turn off the unit before each cleaning.
b) Use only non-corrosive cleaning agents for cleaning the surfaces.
c) After each cleaning, all the parts should be dried well before the unit is used
again.
d) Store the unit in a dry and cool place protected from moisture and direct
sunlight.
e) Do not spray the unit with a stream of water or immerse it in water.
f) Make sure that no water enters through the ventilation openings in the casing.
If the detector finds heavily oxidized iron when using DISC or NOTCH