Electrical Connection - Miele PRI 210 EL Plano De Instalación

en - Installation and planning notes
12
Dismantle the mounting flaps on the left and right sides.

Align the roller and the side columns using the screw feet and a

spirit level. The screw feet under the side columns can be un-
screwed to a maximum of 60 mm.
After levelling the machine secure the screw feet so they cannot

come loose.
Floor anchoring
Suitable anchoring materials for the ironer are available as optional
accessories from the Miele Professional Service Department. Altern-
atively, the tensioning strips that secured the ironer to the transport
pallet for delivery may be used to anchor the machine to the floor.
4 0 m m
2 0 m m
Tensioning strip from the transport pallet

Coin operated ironers must be secured by the side columns to pre-
vent the risk of the machine tipping.

Electrical connection

The electrical connection must be carried out by a qualified electri-
cian who must ensure that all electrical work is completed in ac-
cordance with applicable regulations and standards.
The electrical connection and the wiring diagram are located behind
the mounting flap of the right side column.
Tip: We recommend connecting the ironer to the power supply via a
plug and socket so that it is easier to conduct electrical safety checks
(e.g. during maintenance or repair work).
If the machine is hard wired, an all-pole means of deactivation must
be installed on site. Switches with a minimum contact gap greater
than 3 mm are suitable disconnectors. These include circuit breakers,
fuses and contactors (VDE 0660).
The plug connector or isolator switch should be easily accessible at
all times.