Important Notes - Abus PPIC90600 Guía Rápida

C O M M I S S I O N I N G
For operation with solar panel please ensure:
• The latest firmware version must be installed on your WLAN base station
and WLAN battery cam.
Check version? In the app, follow the path:
Overview -> Menu -> Settings -> Advanced settings -> Device settings ->
Check for firmware update.
The points you must pay attention to when updating the firmware via the
app are described in the operating instructions for the WLAN battery cam.
App
- App2Cam Plus -
• In the settings of the WLAN battery cam that is connected to the solar
panel, the operating mode must be set to „Solar". To do this, follow
the path in the app:
Overview -> Menu -> Settings -> Advanced Settings ->
Camera 1 or 2 Settings -> Operating Mode
16
I M P O R T A N T N O T E S
The best location for your solar panel is where...
 it is installed so that it receives as much sunlight as possible throughout the day:
usually facing the south if in the northern hemisphere (e.g. in Europe, North America, Asia),
or facing the north if in the southern hemisphere (e.g. in South America, Australia).
 it is aligned at an angle of approx. 30° (in relation to an imaginary horizontal line)
Also note the following:
• Regularly remove dust and dirt from the solar panel.
• When the temperature drops below 0° C, the camera is no longer charged via the solar panel so as
to protect the battery
• Make sure the micro USB plug is properly inserted into the micro USB port of the camera for proper
waterproofing.
• If the micro USB plug is not connected to the micro USB port, you must correctly place the rubber
cap on the red cover of the camera for the required waterproofness.
• For information on the ABUS WiFi Battery Cam with base station, please refer to the camera's
operating instructions.
English English
17