Hendi 230268 Manual De Usuario página 8

Control Panel
L1 L2
SW1 SW2
BUTTON
SW1
SW2
SW3
SW4
SW5
SW6
L1
L2
L3
EN
L4
L5
L6
Switching ON
In order to start the machine, press the Button SW6
(ON) for 3 sec. The LED L6 flashes red and a buzzer
sounds.
Procedures before washing
Since the washing machine is switched on, the
boiler and the wash tank start filling with water.
Next, the machine gets filled with detergent and
rinse aid. During these, a "FILL" mes¬sage appears
on the Dash. After the tanks are filled with water
and the necessary detergent and rinse aid liquids
are captured, the boiler's heating resistance and
the wash tank's heating resistance start working
sequentially (after reaching boiler's tempe¬rature
of ope¬ration, its resistance shuts down and the
wash tank starts heating). On the LCD1 & LCD2
8
L3 LCD1
SW3
NAME
CT1
CT2
CT3
DB
CRB
ON
LED TABLE
LED of short cycle selection
LED of medium cycle selection
LED of long cycle selection
Drain in Progress
Cold Rinse Selected
LED of ON/OFF Switch
ALARM LCD2
DESCRIPTION
Short Cycle Button
Medium Cycle Button
Long Cycle Button
Drain Pump Button
Cold Rinse Button
ON/OFF Switch
screens the current temperature of each tank is
displayed alternately (when LCD 1 shows "bt" then
LCD 2 displays boiler's temperature; when LCD 1
shows "tt", then LCD 2 displays tank temperature).
In case that the wash tank's heating resistance is
ON, a dot in the right lower corner of LCD1 is lit,
while in case that the boiler's heating resistance is
ON a dot in the right lower corner of LCD2 is lit. For
that reason, symbol
shown beneath of LCD1 & symbol
ing the boiler) is shown beneath of LCD2.
L4 L5 L6
SW4 SW5 SW6
NOTES
Duration 1 min
Duration 2 min
Duration 3 min
COLOR
(representing the tank) is
(represent-