Cleaning And Maintenance; Environmental Protection - Worx WX891 Manual Original

-- Extend the cable
NOTE: The harder you press, the faster
the flexible shaft will rotate.
ATTENTION: Keep the tool head
at most of 10cm of the pipe
opening. If the distance is too long,
it will cause the flexible shaft to be
twisted and knotted. When tool
head is difficult to approach the
pipe, please use the front guide
tube, preventing injury.
Rotate flexible shaft and entangling
the rubbish
Retract the flexible shaft and bring
out the rubbish
CLEANING AND
MAINTENANCE
Clean the rubbish on the flexible shaft and drain all the
dirty water in the drum, store it in a shade and dry place.
Fully charge battery after work. And store it in a shade
and dry place.
STORAGE AND
MAINTENANCE OF THE
10 10
MACHINE
Before maintenance, please switch off and take off the
battery pack!
After each use, rotate manually the drum and remove
the waterproof plug. Erect tools with head down so that
liquid will drain out and reinstall the waterproof plug.
Do remember to take off the wrench in case of tossing
out next time.
Please clean the flexible shaft and drum carefully. If it
is not to be used for a long time, please apply butter on
the surface of the flexible shaft.
MAINTAIN TOOLS WITH CARE
Remove the battery before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional lubrication
or maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust.
Periodically clear dust and chips from guard and base to
20V Cordless Drain Auger
ensure proper performance.
FOR BATTERY TOOLS
The ambient temperature range for the use and storage
See Fig. C
of tool and battery is 0°C-45°C.
The recommended ambient temperature range for the
charging system during charging is 0°C-40°C.
ENVIRONMENTAL
PROTECTION
See Fig. D
Waste electrical products must not be disposed
See Fig. E
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
TROUBLE SHOOTING
Symptom
The flexible shaft
and rubbish are
stuck in the pipe
and cannot be
retracted
The flexible shaft
cannot wrap
rubbish
Possible Solution
A. Follow Fig. F.
B. If fail, pull out the flexible shaft
by hand.
(1) Put on gloves and remove the
battery;
(2) Push the lever to middle"O"
(F-O-R);
(3) Pull the flexible shaft out of the
pipe by hand and plug it back into
the ratchet.
Push the lever to middle "O" (F-O-R),
flexible shaft will works stay in the
current position.
Push the R & L pusher in turn and
start the machine.
Repeat, observe, until it wraps
rubbish;
Follow Fig. G. Start the machine to
retract the flexible shaft or pull out
it by hand.
EN