Connection And Operation - FONESTAR FO-22CAT8 Manual De Instrucciones

EN
RECEIVER
1.- HDMI OUT: AV signal output for connecting TV, projectors, etc. HDMI connector.
2.- CAT IN: connector for Cat 6/6a/7 cable to connect receiver with transmitter.
- a: receiver power on indicator. Lights up when the receiver receives power..
- b: signal indicator between transmitter and receiver. Lights up when signal transmission is
detected between the transmitter and receiver.
3.- SERVICE: microUSB port for firmware update. Fonestar does not recommend tampering with this input.
4.- IR IN: inputs for connection of remote control IR receivers..
5.- DC 12V: power connection for the power adapter. This connection may be necessary for long cable
lengths where PoE power supply is not possible.

CONNECTION AND OPERATION

- Make the connections with all equipment switched off.
- Connect HDMI signal sources to the IN input of the transmitter.
- Connect the receivers to the transmitter with Cat 6/6a/7 cables.
- Then connect the HDMI OUT outputs of the receivers and the LOOP OUT of the transmitter to the TV
monitors and/or projectors using HDMI cable.
- To use the remote control, you will need to connect the supplied remote control IR emitter to the IR
connector on the transmitter and the remote control IR receivers to the receivers.
OPTIONAL: If you wish to control the splitter extender remotely, use serial communication.
- • Power the transmitter using the supplied power adapter and the receivers only if necessary.
IR Receiver IR Blaster
- 4 -