Husky 34715 Instrucciones De Montaje página 2

Hook up the trailer to the tow vehicle. Lubricate the threads on the handle with a drop of oil and apply
grease to the inside of the sockets at each end of the sway unit. Attach the socket on the slide bar to the sway control
ball on the ball mount. Secure in place, using a spring clip. Turn the On/Off handle 3 turns (or enough so the slide bar
moves freely) counterclockwise to release tension. Place the socket on the main body onto the trailer tongue ball.
Secure in place, using a spring clip.
Turning the On/Off handle clockwise or counterclockwise, until the handle is parallel with the main body. Do not
overtighten the handle. This can bind the friction slide bar. Only tighten the handle enough to allow slide bar resistance.
With a second person watching the sway control & trailer, slowly back the trailer in both directions to a
jackknife position and check that the sway control does not hit the bumper or trailer frame and that it does not become
fully compressed or come apart. If any of these items occur when jackknifed, the sway control must be removed
while backing.
Perform a road test. If this is not enough sway control, then adjust the brake tension screw (#6) ¼ turn
clockwise. Road test again and repeat (if necessary) until the proper amount of sway control is achieved. ¼ turn
counterclockwise if there is too much sway control.
Road & weather conditions, loading & design of the trailer as well as power steering, wheel alignment and the
oscillation point of the tow vehicle & trailer all affect towing characteristics.
Larger or heavier trailers or broad sided trailers may require the use of two sway controls. After a
1,000-mile break in period, remove the slide bar and clean it using a wire brush or steel wool. IMPORTANT! Do
not lubricate or use any cleaning solution on the friction pads or slide bar, dry cloth only. The slide bar should then
be cleaned every 10,000 miles. Check all other mounting bolts and attachment points for the sway control, hitch
and related components every 500 miles, or per the manufacturer's instructions. Whichever is more frequent.
ITEM
1
2
3
4
5
6
7
8
9
10
11
12
13 CLAMP-ON SWAY CONTROL BALL KIT(NO DRILL)
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /
Product Updates. 2020 Keystone Automotive Operations Inc. All Rights Reserved. 09/21/2020-Rev7
DESCRIPTION
MAIN BODY
CRANK HANDLE
WASHER
SLIDE BAR
COMPRESSION PLATE
TENSION ADJUSTMENT SCREW
SELF TAPPING SCREW
SPRING CLIP
BALL, WASHER & NUT ASSY
WELD ON BALL MOUNT
TRAILER TONGUE BALL PLATE
BALL MOUNT ADAPTER, BOXED
Use:
QTY
1
1
1
1
1
1
8
2
1
1 LH 37498 ONLY
1
1
1
IN KIT? SERVICE KIT
YES NA
YES 34847
YES NA
YES 34846
YES NA
YES NA
YES 71195
YES 34853
YES 33842
34845
YES 34842
NO 39585
NO 38964
Page-2