Hardware Installation; English - Genius EasyPen i405X Guia Del Usuario

N : R
O TE E MO VE T HE S C R E E N PR O TE C TO R B E F O R E U S I N G T HE TA B LE T
INTRODUCTION

HARDWARE INSTALLATION

CAUTION: MAKE SURE THAT YOU HAVE INSTALLED THE DRIVER
SOFTWARE (SEE ABOVE) INTO YOUR COMPUTER BEFORE
INSTALLING THE HARDWARE.
1. Plug the Graphic Tablet USB cable into your computer's USB port (located on the
computer, display, or keyboard). The Graphic Tablet's LED light will indicate
the operational status, and your computer screen will display a "found new
hardware" message.
VERIFYING THE INSTALLATION
The LED light on the Tablet Plate is the main indicator for hardware operation. The light normally stays off, and will
come on and off in response to various conditions. Watch the status of the Tablet Plate LED light as you go through
these steps. None of the tests, except the last two, require the tablet driver to be installed.
For the cordless pen (stylus) or the wireless mouse , tap on any surface or press the left button of the mouse to "wake
1.
it up", in case the pen or the mouse has gone to "sleep" after it is not used for a few minutes.
As soon as the Tablet Plate receives power, the LED light will come on briefly, and will normally stay off.
2.
When the working area (Plate) detects the presence of the pen, the LED light will flash slowly. This happens when
3.
the pen tip is directly above the working area of the tablet plate and is low enough.
When you press a button on the body of the pen or the mouse, the LED light will come on.
4.
When you press the pen tip against the tablet plate anywhere in the working area, the light will also come on.
5.
G G
E N I U S
Q U I C K I N S T A L L A T I O N G U I D E
T
R A P HI C A B L E T
1. Working area
2. Hot Cell
3. LED indicator
4. Button 2
5. Button 1
6. Pen tip
1

ENGLISH

.