Technical Data; Troubleshooting - Urrea CE913 Manual De Usuario Y Garantía

resin and other accumulations from feed roll-
ers and table with a non-flamable solvent.

TROUBLESHOOTING

FUZZY GRAIN
Planing wood with high moisture content. Dry
the wood.
Dull blades. Sharpen blades.
TORN GRAIN
Too heavy a cut. Review proper depth of cut.
Blades cutting against the grain. Feed wood
with the grain, or turn workpiece around.
Dull blades. Sharpen blades.
ROUGH/RAISED GRAIN
Dull blades. Sharpen blades.
Tool heavy a cut. Check proper depth of cut.
Moisture content too high. Dry the wood.
Cutterhead bearings damages. Replace bear-
ings.
UNEVEN DEPTH OF CUT SIDE TO SIDE
Blade projection not uniform. Adjust blade
projection.
Cutterhead not levelled to planer bed. Level
cutterhead to table.
BOARD THICKNESS DOESN'T MATCH DEPTH
OF CUT SCALE
Depth of cut scale incorrect. Adjust depth of
cut scale.
CHAIN JUMPING
Sprockets misaligned. Align sprockets.
Sprockets worn. Replace sprockets.
MACHINE WON'T START / RESTART
Not plugged in. Check power source.
Circuit breaker / fuse. Check power source.
Motor failure. Have motor checked.
Loose wire. Have motor checked by an autho-
rised service center.
Overload reset has not reset. Allow machine to
cool down and restart.
Motor starter failure. Have motor starter
checked by an authorised service center.
E N G L I S H •
REPEATED CIRCUIT TRIPPING RESULTING IN
MOTOR STOPPAGE
Extension cord too long or too thin. Use a
shorter or thicker extension cord.
Blades too dul. Sharpen or replace blades.
Low voltage running. Check voltage.
POOR FEEDING OF TIMBER
Planer table dirty. Clean off pitch and residue,
and lubricate planer table.
Feed roller damaged. Replace.
Sprocket damaged. Replace.
Gear box malfunction. Check gear box.
WORKPIECE JAMMED
Inadequate blade setting height. Set the blade
to the correct height.

TECHNICAL DATA

VOLTAGE-FREQUENCY
PHASES
PLANING LENGHT
PLANING WIDTH
PLANING HEIGHT
FEEDING SPEED
DEPTH OF CUT
POWER
WEIGHT
U se r 's m a nu a l
120 V ~ 60 Hz
1 ~
5" (127 mm)
12 3/16" (309 mm)
5 mm- 153 mm
(4 - 6) m/min
3 mm
2 1/2 HP
33 kg (73 lb)
17