Maintenance And Cleaning - Flama 727FL Manual De Instrucciones

If you want to stop heating, to get hot
water without boiling, just turn the on/off
switch to the "0" position and it turns off
automatically (the indicator goes off).
If you want to reheat (reheat) the water, fit
the kettle to the power base, set the on/off
switch to the "I" position to turn the kettle
on (and the indicator light comes on).
After the water comes to a boil and the
kettle switches off automatically, a few
drops of water may appear on the hopper.
This is normal, it results from condensation
generated during operation, and water
appears through the holes in the bottom of
the kettle.
Before putting the kettle back into
operation, unplug the plug from the socket
and wipe off the water with a dry, absorbent
cloth.
Never run the water kettle with the power
base wet.
If by accident, pour water into the power
base, proceed as follows:
- disconnect the plug from the socket.
- clean the infeed base with a dry, absorbent
cloth.
- clean the surface where the power base
is placed.
- connect the plug to the socket and restart
use.
If you carelessly put the kettle to work
without water, the safety device that
prevents overheating will actuate and turn
it off. In this situation, remove the kettle
from the feed base; let it cool down; fill with
water without exceeding the maximum
level indicator; place the kettle on the
power base and reconnect.
Never put cold water in a very hot kettle, as
you run the risk of getting burned.

MAINTENANCE AND CLEANING

After each use and before proceeding with
any cleaning operation, always unplug the
plug from the socket and allow the kettle
to cool down. Descaling extends the life of
the electric kettle, improves its behaviour,
reduces electricity
guarantees the correct functioning of the
safety system that prevents overheating.
Never immerse the kettle or feed base in
water or any other liquid.
Clean the outside of the kettle and the feed
base with a dry, absorbent cloth.
Do not use abrasive products.
How to remove the filter:
To remove the kettle filter for cleaning,
remove the kettle from the spout base and
allow to cool. Do not remove the kettle
filter if it is still hot or filled with water.
- Open the lid by pressing the open button.
- Remove the filter. Carry out the cleaning
operation.
Place the filter in the same place, making
sure it is properly placed.
Do not use the kettle before making sure
the filter is correctly placed.
DESCALING
You should descale the electric kettle
monthly, or more often depending on the
lime scale in the water and how often you
use the kettle.
To remove limescale stains from the inside
of the body, periodically descale the jar
using one of the following methods:
- Use a liquid descaling agent, available in
commerce or at authorized Flama after
English
consumption and
15