Electrical Information - Herschel HAWAII 2000 Instrucciones De Instalación Y Funcionamiento

instruction or are under supervision. Children should be kept away and should not be left unsupervised
around the unit.
11. All operators shall only switch on/off the appliance provided that it has been placed or installed in its
intended normal operating position and they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the hazards involved. Children shall not plug in,
switch on or regulate the appliance or perform user maintenance including cleaning.
DO NOT
12. leave the heater operating unattended.
NEVER
13. place hands under the heating element during operation.
IMPORTANT:
14.
SAVE THESE INSTRUCTIONS.
WATER INGRESS PROTECTION:
Herschel HAWAII is rated to a standard IP44. Suitable for outdoor use.
If the HAWAII is hung or installed from a canopy/roof 300mm clearance must be maintained at all times.
Installation in areas such as outdoor bathrooms, pools or hot tubs must be carried out by a suitably qualified
installer and comply with local electrical safety requirements.
If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, damage or injury caused or
resulting from inadequate fitting or incorrect placement of heaters close to water sources.

ELECTRICAL INFORMATION:

The Hawaii 2000 may be plugged in to a waterproof socket. Any extension lead used must have sufficient
capacity to carry the current required by the heater as show in in Table 1. All plugs, sockets and switches
intended for use outdoors must have an appropriate water ingress protection.
Alternatively the plug can be removed and the unit connected to fixed mains wiring. Fixed wiring
installations must only be carried out by competent persons or a qualified electrician according to national
regulations and the unit must be earthed. The electrical supply to the unit should be provided by connecting
to a current protection device suitable for the electrical rating of the unit in accordance with Table 1 and
providing disconnection in both poles. All fixed wiring must have sufficient capacity to carry the current
required by the heater.
Always disconnect the heater from the power when not in use.
Table 1. Electrical Specification
Model
Voltage
Rated Power
Current
Frequency
Cable Colour
Ensure supply voltage does not exceed 245 Volts.
HAWAII 2000
220 – 240V
2000 Watts
9 Amps
50 Hz
Brown, Blue, Yellow/Green
ENGLISH