Special Safety Instructions For Coffee Makers; Operation; Inserting/Removing The Rechargeable Battery; Charge Level Indicator - Parkside PKMA 20-Li A1 Manual De Instrucciones

GB IE
Special safety instructions
for coffee makers
Observe the following inst-
ructions to avoid the risk of
scalding:
• Do not remove the filter holder/coffee
pod holder during the brewing cycle.
There is a danger of burns from the hot
steam.
• Please be aware that hot coffee may drip
from the underside of the filter holder/
coffee pod holder even after the brewing
cycle is complete.
• Wait at least 5 minutes after the brewing
cycle ends before removing the filter hol-
der/coffee pod holder.
• If you wish to start another brewing cyc-
le, wait at least 5 minutes before re-filling
the device with water. Otherwise steam
and hot water may flow out and cause
scalding.
• Do not touch the plate on the underside
of the device during or directly after
brewing.
• Do not use any liquid other than water
for brewing.
• Always use cold water for brewing.
Hot water increases the drip speed and
leads to overflowing of the filter holder/
coffee pod holder.
• The maximum water tank volume totals
240 ml. Do not pour too much water into
the water tank (
may run out of the overflow opening (
4).
• Do not allow water to stay in the tank for
longer than 24 hours.
• After use, the surfaces of the heating ele-
ment may contain residual heat. There is
a risk of burns.
20
5). Excessive water

Operation

Inserting/removing the
rechargeable battery
1. To insert the battery (17) into the de-
vice, push the battery (17) along the
guide rails (21) into the device. You
will hear it click into place.
2. To remove the battery (17) from the
device, press the release button (20)
on the battery (17) and pull the battery
(17) out.

Charge level indicator

The battery charge status indicator (19)
shows the charge status of the battery (17).
The charge level of the battery (17) is indi-
cated by illumination of the corresponding
LED light. To see this, press the soft button
(18) on the battery charge level indicator
(19).
3 LEDs illuminated (red, orange and green):
Battery charged
2 LEDs illuminated (red and orange):
Battery partially charged
1 LED illuminated (red):
Battery needs to be charged
Low battery voltage:
If the remaining battery capacity is too
low, the device will not work. The voltage
14) will flash in this situati-
indicator (
on. Remove the battery (17) from the de-
vice and charge it.