Overheating Protection; Cleaning / Maintenance; Cleaning & Maintenance; General Cleaning And Maintenance Work - Parkside PKMA 20-Li A1 Manual De Instrucciones

GB IE
7. Place the lid (
cup ( 10) and place the cup onto
the cup holder (
8. Press the on-off button (
power indicator (
and the brewing will commence.
9. Once the brewing cycle is complete, the
device will switch off automatically and
the power indicator (
out. Press the on-off button (
you want to cancel the brewing cycle.
10. Dispose of the coffee grounds and
used coffee pods properly.
If the filter holder/coffee pod
holder (
during the brewing cycle, this
can be caused by various
factors. In this event, observe
the information in the "Trou-
bleshooting" section

Overheating protection

If the device does not start, the battery
( 17) or device is overheated. In this
event, allow the battery (
vice to cool down before re-pressing the
on-off button (

Cleaning / maintenance

Have any work that is not
described in these instruc-
tions performed by an autho-
rised customer service centre.
Only use original parts.
22
11) onto the coffee
7).
13). The
14) will light up
14) will go
13) if
8/9) overflows
17) and de-
13).
General cleaning and main-
tenance work
Do not spray down the de-
vice with water. There is a
risk of electric shock.
• Do not submerge the device in water
under any circumstances.
• Never use petrol, benzene, thinner, al-
cohol or the like to clean plastic parts.
Such agents can cause discolouration,
deformation or cracking.
• Let the device cool down before remo-
ving dirt, dust, oil, grease, etc. with a
clean cloth.
• Do not use abrasive cleaners or abrasi-
ve pads.
• Do not wipe the inside of the device
with a cloth; fluff may be left behind.
• Take proper care of your device so that
it will serve you well for years to come.
• Thoroughly clean the device after eve-
ry use to maintain the quality of coffee
produced.
• Check the covers and protective de-
vices for damage and correct fit. Re-
place these if necessary.

Cleaning after every use

1. Remove the battery (
device and allow the device to cool
down.
2. Wipe the case with a soft cloth dam-
pened with soapy water.
3. Remove the water tank (
8), coffee filter insert
holder (
( 6), coffee pod holder (
coffee cup (
( 11) and measuring spoon
( 15) from the device. Wash the
parts in hot, soapy water, and then
rinse them with hot water.
17) from the
5), filter
9),
10), coffee cup lid