Description Of Spare Parts - KNOVA KN GEN-16 Manual Del Usuario

DESCRIPTION OF SPARE PARTS

(1)
(2)
(3)
(1) Chock valve
(2) Air cleaner
(3) Starter grip
(4) Oil drain bolt
Fuel tank It is used to hold fuel, gasoline is allowed only.
Fuel Screw the fuel injection port in use and do not
tank cap open it in equipment operation.
AC output socket provides the power supply.,
AC
Please refer to model's parameter table for
output
its rated power. load of each socket cannot
exceed its rated current, and total power of
electric device cannot surpass rated power of
the generator Do not start up several electric
devices simultaneously, but switch on another
one after stable operation of one electric device.
AC circuit It will break to protect the electric device
breaker when current is too heavy.
Output
It is to indicate power supply status.
indicator
The indicate will brighten up when
the equipment operation.
Engine
It is to start up (applicable to electrical
switch
starting only) and switch off engine.
Turn to the off state in nonuse.
Oil filler It is for measurement of engine's oil level.
cap Make sure engine's oil level is between MIN and
MAX in the dipstick of oil filler cap before use.
Oil can be added after removing the oil filler cap.
Oil drain Unscrew this bolt when replacing the engine
bolt oil. Drain out the old engine oil and dispose of
it properly according to local laws, avoiding
damage to the environment.
Grounding It is to make the generator realize safe grounding.
terminal As to the grounding method, refer to the page
5. Make sure unobstructed grounding before use.
Starter It is to start up the engine.
grip For the method, refer to the page 5.
(10)
(5)
(4)
(5) Oil filler cap
(6) Engine switch
(7) AC output
(8) Output indicator
(12)
(9)
(8)
(7)
(6)
(14)
(13)
(9) Control panel
(10) Circuit breaker
(11) Fuel tank cap
(12) Fuel tank
Air It is to filter air and remove impurities
cleaner in the air entering cylinder. As to the
maintenance method, refer to page 8.
It is to control fuel's entering into the engine
Fuel
via fuel tank During nonuse of generator,
switch
leave the switch off.
Choke It is to control air flow into the cylinder when
valve starting up the engine. As to the
operating method, refer to the page 6.
Muffler It is to eliminate noise during equipment
operation, and discharge high temperature
exhaust of engine's combustion. Do not touch
it to avoid scalding.
Sockets can be
following patterns
according
to relevant
regulations in
various areas:
WARNING
When the
rated current from
one socket output
more than the
socket's nominal
rated current, you
should to use
simultaneously
two or more
sockets for
power output.
4
(11)
(13) Cover, generator end
(14) Muffler
(15) Cylinder head
(16) Carburetor
(17) Spark plug
(17)
(16)
(15)